Teltronics SEB NET-PATH, Installation And Operation Manual

Page: 11 / 82

NET-PATH Installation and Operation Guide
v
The Canadian Department of Communications requires notification of the following:
• Equipment Manufacturer: Teltronics, Inc.
• Equipment Load Number: SEBea – 9
• Connecting arrangement code: CA11A
The load number (LN) assigned to each terminal device denotes the ratio of its load to
the total load connected to a telephone loop. The load number is used by the device to
prevent overloading. The termination on a loop may consist of any combination of
devices, subject only to the requirement that the load number total for all the devices
does not exceed 100.
This digital apparatus does not exceed the Class A limits for radio noise emissions
from digital apparatus set out in the Radio Interference Regulations of the Canadian
Department of Communications.
Le présent appareil numérique n'émet pas de bruits radioélectriques dépassent les
limites applicables aux appareils numérique de la class A prescrites dans le Réglement
sur le brouillage radioélectrique édicté par le ministére des Communications du
Canada.
Professional installation only, no user-serviceable parts inside except as indicated in
this installation guide.
Important Safety Instructions
When using your telephone equipment, basic safety precautions should always be
followed to reduce the risk of fire, electric shock and injury to persons, including the
following:
• Do not use this product near water, for example, near a bath tub, wash bowl,
kitchen sink or laundry tub, in a wet basement or near a swimming pool.
• Avoid using a telephone (other than a cordless type) during an electrical storm.
There may be a remote risk of electric shock from lightning
• Do not use the telephone to report a gas leak in the vicinity of the leak.
• Use only the power cord and batteries indicated in this manual. Do not dispose of
batteries in a fire. They may explode. Check with local codes for possible special
disposal instructions.
Warning
Danger of explosion if battery is incorrectly
replaced. Replace only with the same or equivalent type
recommended by the manufacturer. Dispose of used
batteries according to the manufacturer's instructions.”