107
Hold SWITCH down till LED stars blinking
Release the SWITCH
Then LED starts blinking and counting first digit of program number, (one blink
means digit 1, two blink digit 2 etc.)
To stop counter push SWITCH
Release the SWITCH, then LED starts blinking and counting second digit of program
number
To stop counter push SWITCH
Release the SWITCH, then LED starts blinking and counting third digit on program
number
To stop counter push SWITCH
Release SWITCH, if programming is succeded LED will blink 10 times
Figure 81 Adapter signaling led
15.2.3
Program number logic change
Due to the growing number of supported cars, program numbers have exceeded 999. In
order to maintain one number format, we are moving from 3 digits, to 4 digits program numbers.
In new LV-CAN200/ALL-CAN300 firmware (from 2017-09-01) all program numbers that
were up to 999 are changed to start from 1000. So that further program numbers would
continue the counting with 4 digit numbers.
However, all existing program numbers stays the same, it is just "1" appeared in front of
them. Device still understands entered 3 digit program number (via SMS/GPRS), it will
automatically add "1" before it. If you enter "247" - device will turn it into the "1247". In
Bootloader it is only 4 digit format available, just add "1" in from of the needed program number.
