Telrad CPE-12000SG-PRO-1D-3 Series, User Manual

Page: 108 / 110

LTE Outdoor CPE12000 | User Manual 108
Monitoring | Diagnostic Tools
Monitor > Diagnostic Tools
CPE has built-in tools “ping” and “traceroute”. “Ping” is used to test if CPE can reach an IP
address or domain by sending the ICMP “ECHO_REQUEST” packet and waiting for the ICMP
“ECHO_RESPONSE” packet. “traceroute” records all the relay points from CPE to an IP
address or domain. The result of “ping” and “traceroute” will be presented in “Diagnostic
Result”.
Settings

Status: Enable/Disable the tool.

Diagnostic Type: ping or traceroute.

IP Address/Domain: The IP address or domain name for CPE to connect.

Ping Count (Diagnostic Type: Ping): Stop after sending “Ping Count” packets.

Packet Size (Diagnostic Type: Ping): As titled.

Ping Timeout (Diagnostic Type: Ping): Time to wait for the response packet back to
CPE.

Max Hops (Diagnostic Type: Traceroute) : The number of relay point that a packet
can pass by.
Diagnostic Result : The result of “Ping” or “Traceroute” will be shown here.