Telos Zephyr, User Manual

Page: 73 / 258

Section 4 INSTALLATION &
BASIC OP
73
Using Auto Dial
Permits recalling stored set- ups and numbers and then connecting according to the
stored parameters and numbers. The autodial function will recall codec modes as well
as telephone numbers. For instance, you may have someone you connect to in G.722
mono at 56kbps, while others need Layer III stereo at 64kbps.
The third LCD line follows the DISPLAY parameter – you may look at the NAME text,
either of the two stored telephone NUMbers, or the system MODE to ensure that you
have what you want.
The autodialer will dial one or both lines depending upon whether one or two numbers
were stored initially.
After a valid selection is made, press <AUTODIAL> again to connect.
Press the <
AUTO DIAL
> button:
Auto Dial: [ 1 ]
Display NAME
Telos Test Line
<+/-> or <AUTODIAL>
There are 50 possible auto dial set- ups. This example screen indicates that the Telos
test line is programmed into the #1 set- up. With the brackets around the Auto Dial
number value, press the <
-NO> or <YES > button to see other set- ups:
Auto Dial: [ 2 ]
Display NAME
Mr Voice-over
<+/-> or <AUTODIAL>
You can also choose an setup using the keypad to type it’s 2 digit number. For instance
press
<0, 1> to see another set- up:
Auto Dial: [ 1 ]
Display NAME
Telos Test Line
<+/-> or <AUTODIAL>
The Display parameter on the screen above selects that we see the Name of the set- up
on the LCD third line. To see the programmed telephone number for this set- up, the
Display value can be changed by moving the brackets Display by using the
<SEL>
buttons and pressing
<YES +>
to select
NUM1
: