T. E. L. L. SOFTWARE
HUNGÁRIA KFT
51
11.1.2
DSC alarm control panel
Installation settings:
Figure 56.
Connect a programming cable to the alarm control panel, then connect its serial port output with the module
(see Figure 56. above). Only RX, TX and GND wires will be used, please connect these to the module in the
order shown in Figure 56. above.
Software settings:
Open the module's web interface, set the data for the serial port operation in the
Remote Modules
menu as
shown below:
Figure 57
.
Remote module:
Select the „Receive only” option from the dropdown list.
