Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page
19 of 49
Communications between your application and the Telit modules are allowed connecting the
DTE to the Asynchronous Serial Interfaces of Base-Band Chip, USIF0 and USIF1, through
the two standard RS232 communications ports (9 way D-socket connector at slow data rates
of RS232 protocol) or a standard Mini USB receptacle.
The selection between D-Socket and USB is done using the SW901 switch.
USB Mode:
RS232 Mode:
PL401 has to be set with a Jumper between pin 2 and 3
Summary of Contents for xE910
Page 1: ......
