Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page
11 of 49
The motherboard factory setup is:
Serial port
USIF 0 and USIF 1 on USB UART
DC source
12V only
Audio
Available on MIC/EAR
DVI connected
Follow this sequence of commands to use the Development Board:
insert your SIM card
set properly all jumpers in the desired position
connect the antenna to RF connector
connect the audio accessories if required
Insert the module in the Socket (ensure to properly place the module in it following the
A1 pin reference as in the below picture).
Close the Socket
plug the 12V power supply into the +12V_IN
switch ON the power supply
connect the serial cable between your PC and UART (RS232 or USB MAIN)
push ON/OFF button for at least 5 seconds
Your module should now be operational and ready to receive AT Commands.
Summary of Contents for xE910
Page 1: ......
