WE310F5-X IP2WiFi Legacy AT Command Reference Guide
80664ST11079A Rev. 3
Page 34 of 79
2021-10-25
Not Subject to NDA
MAC
All new WE310F5-X
modules will have “00:21:7E:xx:xx:xx” as MAC address with Telit
Organizational Unique Identifier (OUI).
6.7.1.
Get MAC Address
Command Description
This command is used to output the current MAC address of the wireless interface to the
serial port.
Note/Tip:
1.) The Telit node is stored with two MAC addresses. One when it is in
STA mode andtheotherwhenitisinAPmode.
The MAC address printed on the Telit node is for STA mode.
STA MAC a 1 is the MAC address for AP mode.
2.) To get the current MAC address for the Telit node in STA mode,
execute the command AT+WM=0 followed by the AT+NMAC=?
command.
3.) To get the current MAC address for the Telit node in AP mode,
execute the command AT+WM=2 followed by the AT+NMAC=?
command..
Command Syntax
AT+NMAC?
Synchronous Response
Table 33: Get MAC Address Synchronous Response.
Responses
Remarks
OK
Success
Example 1
To get the current MAC address for the Telit node in STA mode,
execute the following sequence of commands:
AT+WM=0
OK
AT+NMAC=?
00:1d:c9:d0:70:cc
OK
