SL869-3DR Evaluation Kit User Guide
1VV0301266 r0
2016-11-14
Reproduction forbidden without written authorization from Telit Communications S.p.A. - All Rights
Reserved.
Page 33 of 35
Mod. 0810 2011-07 Rev.2
7.
Flashing Firmware with TeseoIII X-Loader
Note that X-loader requires use of the BOOT pin. If this pin is not available in a user’s design,
you will need to run the FW Upgrade Tool (UPG).
The EVK will be preloaded with firmware, however if updates are required, perform the
following steps:
7.1.
Flashing Requirements
•
SL869-3DR software from TELIT
•
TESEOIII X-Loader v1.13 (or newer) from TELIT
7.2.
Flashing Instructions
Note: Do not erase NVM, or the Initialization procedure will have to be performed.
1.
Install a shunt jumper on Main Board SL869 BOOT (pins 2 & 3), shorting the pins together.
2.
Connect the USB cable and let the Host PC machine enumerate the USB connection.
3.
Set SW201 (Main Power) to ON (up) to power the SL869-3DR receiver.
4.
Launch the TESEOIII X-Loader and set the selections as shown in the figure below.
Figure 7-1 TESEOIII X-Loader
√
