xN930 M.2 Hardware User Guide
The conformity assessment procedure referred to in Article 10 and detailed in Annex IV of
Directive 1999/5/EC has been followed with the involvement of the following Notified
Body:
Thus, the following marking is included in the product:
The full declaration of conformity can be found on the following address:
There is no restriction for the commercialization in all the countries of the European Union.
Final product integrating this module must be assessed against essential requirements of
the 1999/5/EC (R&TTE) Directive. It should be noted that assessment does not necessarily
lead to testing. Telit Communications S.p.A. recommends carrying out the following
assessments:
RF spectrum use (R&TTE art.
3.2)
It will depend on the antenna used on the final
product.
EMC (R&TTE art. 3.1b)
Testing
Health & Safety (R&TTE art.
3.1a)
Testing
Alternately, assessment of the final product against EMC (Art. 3.1b) and Electrical safety
(Art. 3.1a) essential requirements can be done against the essential requirements of the
EMC and the LVD Directives:
•
Low Voltage Directive 2006/95/EC and product safety
•
Directive EMC 2004/108/EC
for conformity for EMC
12.2
CE RF Exposure Compliance
This device meets the EU requirements (1999/519/EC) and the International Commission on
Non-Ionizing Radiation Protection (ICNIRP) on the limitation of exposure of the general
public to electromagnetic fields by way of health protection.
To comply with the RF exposure requirements, this module must be installed in a host
platform that is intended to be operated in a minimum of 20 cm separation distance to the user.
Reproduction forbidden without written authorization from Telit Communications S.p.A. - All Rights Reserved.
Page 72 of 77
