LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 161 of 273
#MWI - Message Waiting Indication
AT#MWI=<enable>
Set command enables/disables the presentation of the
message waiting indicator
URC.
Parameter:
<enable>
0 - disable the presentation of the
#MWI
URC
1 - enable the presentation of the
#MWI
URC each time a new message waiting
indicator is received from the network and, at startup, the presentation of the
status of the
message waiting indicators
, as they are currently stored on
SIM
.(Factory default)
The URC format is:
#MWI: <status>,<indicator>[,<count>]
where:
<status>
0 - clear: it has been deleted one of the messages related to the indicator
<indicator>
.
1 - set: there’s a new waiting message related to the indicator
<indicator>
<indicator>
1 - either Line 1 (CPHS context) or Voice (3GPP context)
2 - Line 2 (CPHS context only)
3 - Fax
4 - E-mail
5 - Other
<count>
- message counter: network information reporting the number of pending
messages related to the message waiting indicator
<indicator>
.
The presentation at startup of the
message waiting indicators
status, as they are
currently stored on SIM, is as follows:
#MWI: <status>[,<indicator>[,<count>][<CR><LF>
#MWI: <status>,<indicator>[,<count>][...]]]
where:
<status>
0 - no waiting message indicator is currently set: if this the case no other
information is reported
1 - there are waiting messages related to the message waiting indicator
<indicator>
.
<indicator>
1 - either Line 1 (CPHS context) or Voice (3GPP context)
2 - Line 2 (CPHS context)
3 - Fax
Summary of Contents for LE910-SKG
Page 1: ......