LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 158 of 273
#RFSTS – Read Current Network Status in E-UTRAN
38 - RR_STATE_MAX
AT#RFSTS=?
Test command
returns the OK result code.
#QSS - Query SIM Status
AT#QSS=
[<mode>]
Set command enables/disables the Query SIM Status unsolicited indication in the
ME.
Parameter:
<mode>
- type of notification
0 - disabled (factory default); it’s possible only to query the current SIM status
through Read command
AT#QSS?
1 - enabled; the ME informs at every SIM status change through the following
unsolicited indication:
#QSS: <status>
where:
<status>
- current SIM status
0 - SIM NOT INSERTED
1 - SIM INSERTED
2 - enabled; the ME informs at every SIM status change through the following
unsolicited indication:
#QSS: <status>
where:
<status>
- current SIM status
0 - SIM NOT INSERTED
1 - SIM INSERTED
2 - SIM INSERTED and PIN UNLOCKED
3 - SIM INSERTED and READY (SMS and Phonebook access are possible).
Note: the command reports the SIM status change after the <mode> has been set to
2. We suggest to set <mode>=2 and save the value in the user profile, then power
off the module. The proper SIM status will be available at the next power on.
AT#QSS?
Read command reports whether the unsolicited indication
#QSS
is currently
enabled or not, along with the SIM status, in the format:
#QSS: <mode>,<status>
(
<mode>
and
<status>
are described above)
AT#QSS=?
Test command returns the supported range of values for parameter
<mode>
.
Example
AT#QSS?
#QSS:0,1
Summary of Contents for LE910-SKG
Page 1: ......