Telit Wireless Solutions LE910-SKG, At Commands Reference Manual

Page: 122 / 273

LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 122 of 273
+CRES - Restore Settings
Note: If parameter is omitted the command restores message service settings from
NVM.
AT+CRES=? Test command returns the possible range of values for the parameter <profile> .
Reference 3GPP TS 27.005
+CMMS – More Message to Send
AT+CMMS=[<n>]
Set command controls the continuity of SMS relay protocol link.
Multiple messages can be sent much faster as link is kept open.
Parameter:
<n>
0 – Disable (factory default)
1 - Keep link opened while messages are sent. If the delay between two messages
exceeds 3 seconds, the link is closed and the parameter <n> is automatically res
et to 0: the feature is disabled.
2 - Keep link opened while messages are sent. If the delay between two messages
exceeds 3 seconds, the link is closed but the parameter <n> remains set to 2: the
feature is still enabled.
AT+CMMS? Read command reports the current value of the parameter <n>.
AT+CMMS=? Test command reports the supported value of <n> parameter.
Reference 3GPP TS 27.005
+CNMI - New Message Indications To Terminal Equipment
AT+CNMI=[
<mode>[,<mt>
[,<bm>[,<ds>
[,<bfr>]]]]]
Set command selects the behaviour of the device on how the receiving of new
messages from the network is indicated to the
DTE .
Parameter:
<mode> - unsolicited result codes buffering option
0 - Buffer unsolicited result codes in the TA . If TA result code buffer is full,
indications can be buffered in some other place or the oldest indications may
be discarded and replaced with the new received indications.
1 - Discard indication and reject new received message unsolicited result codes
when TA-TE link is reserved, otherwise forward them directly to the TE .
2 - Buffer unsolicited result codes in the TA in case the DTE is busy and flush
them to the TE after reservation. Otherwise forward them directly to the TE.
3 - Forward unsolicited result codes directly to the TE. The hardware Ring line
Indicator for 1 second is enabled when a new message is received while the
module is in EPS on-line data mode.