S50 Hardware User Guide
1VV0301505 Rev. 3
Page 46 of 60
2021-05-05
Not Subject to NDA
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
9.2.5.
FCC RF-exposure Statement
The S50/AI and S50/AP, if used with the antenna described in chapter
7.5 OEM Layout and Antenna Selection in Respect to RED/FCC/IC Certification, do comply
with the FCC/IC RF radiation exposure limits set forth for an uncontrolled environment.
According to table 1B of 47 CFR 1.11310 “Limits for Maximum Permissible Exposure
(MPE), Limits for General Population / Uncontrolled Exposure” the power
density at 20
cm distance to the human body is well below the limit of 1mW/cm2.
Note/Tip: For the S50/AI the distance to the human body may
be 0cm. The same applies for the S50/AP if the specific
antenna stated in 7.5 OEM Layout and Antenna Selection in Respect to
RED/FCC/IC Certification is used. But if a different antenna is used,
MPE must be re-evaluated.
9.2.6.
FCC Labeling Requirements for the End Product
Any End Product integrating the S50/AI or S50/AP must be labeled
with at least the following information:
This device contains transmitter with:
FCC ID: RFR-S50
IC:
4957A-S50
9.3.
IC Compliance
The S50/AI and S50/AP have been tested to fulfill the IC
requirements. Test reports RSS-210 of Industry Canada are available on request.
9.3.1.
IC Grant
The actual version of the IC Grants can be downloaded from the Telit Download Zone:
https://www.telit.com/support-training/download-zone/
Take note that you must register to get access to the Download Zone.
