S42
Hardware User Guide
1VV0301303 Rev. 11
Page 61 of 85
2021-05-06
Not Subject to NDA
The output power is < 10mW
EIRP
and therefore according to “FCC KDB 4474
98 D01
General RF Expo
sure Guidance v05” Appendix A, table “SAR Exclusion Threshold”,
excluded from SAR testing for test separation distances
≥
5mm and if it is not used in co-
locations with other antennas. If the product implementing the S42/AI has
other antennas in co-location or separation distances < 5mm an FCC TCB should be
asked for a Class II Permissive Change.
8.2.6.
FCC Labeling Requirements for the End Product
Any End Product integrating the S42/AI must be labeled with at least the
following information:
This device contains transmitter with
FCC ID: RFRMS42
IC:
4957A-MS42
8.3.
IC Compliance
The S42/AI has been tested to fulfill the IC requirements. Test reports RSS-210
of Industry Canada are available on request. Grant of the Full Modular Approval is shown
below.
