Telindus 1031, User And Reference Manual

Page: 42 / 394

Telindus 1031 Router Chapter 3
User manual DIP switches of the Telindus 1031 Router
32
3.3 Opening and closing the housing
When you want to change the DIP switch settings, you have to open and close the housing of the Telin-
dus 1031 Router. This section explains how to do so.
Opening the housing
To open the housing of the Telindus 1031 Router, proceed as follows:
Closing the housing
To close the housing of the Telindus 1031 Router, proceed as follows:
Step Action
1 Disconnect the external power supply.
2 Unscrew the two screws located at the back of the
housing.
3 Remove the cover as follows:
1. Carefully lift the back of the cover a
few centimetres.
2. Gently pull the cover backwards from
under the nose of the housing.
Step Action
1 Replace the cover as follows:
1. Gently push the cover under the
nose of the housing.
2. Lower the back of the cover.
3. Push on the back of the cover, click-
ing cover and bottom together.
2 Fasten the two screws located at the back of the
housing.
3 Reconnect the external power supply.
1
2
2
1