9
3
Operation Set up
The operation set-up of the Asset Tracking device can be realized in few quick steps.
Please take proper measures for ESD protection (e.g. electrical connection
of the body to ground) to make sure you do not destroy internal
electronics! Repair of ESD damages caused by user’s negligence will not be
covered by Telic’s warranty.
Electrostatic discharge (ESD) is the sudden and momentary electric current that
flows between two objects at different electrical potentials normally caused by
static electricity.
3.1
Schematics of the device
The following figure shows the physical dimensions of the housing and should assist in mounting
the device:
Figure 3: Physical Dimensions of the housing
3.2
Opening the device
Open the Picotrack Endurance housing by removing the screws on the outside edge of the housing
(see Figure below). When the screws are removed lift the top of the device in order to reveal the
circuit board underneath.
3.3
Inserting the SIM Card
A working SIM card from a suitable network provider must be properly inserted in order for the
device to operate correctly.
