Disassembly | en
21
Bosch Security Systems, LLC
Customer Maintenance Manual
2020-07 | 01 | F.01U.387.060
6
Disassembly
The following procedure describes the complete disassembly of the Airman 8+ headset.
Notice!
The removal process requires the following steps to be followed in the order described.
Assembly is the reversal of the disassembly procedure. Please take car when disassembling to
note details that may be required in the reassembly process, such as the locations of
disconnected wires.
When soldering, be careful not to touch the plastic housing of the headset/headphone with
the soldering iron.
Notice!
Only disassemble parts that are necessary for the repair.
6.1
Ear cushion replacement
To ensure optimal product performance, replace cushions and pads periodically.
For the recommended maintenance schedule, please refer to
replace the ear cushions
, do the following:
1.
Grasp the
edge of the ear cushion
where it folds into the slot on the ear cup.
2.
Gently pull the
ear cushion up and away
from the ear cup.
3.
Starting at the
top of the ear cup
(1), carefully work the
cushion around the cup
(2) until
it is
in place
(3).
1
2
3
4.
Verify the
replacement
is acceptable by visually inspecting around the cushion before
use.
