Teletek electronics iRIS8, Engineer Programming Manual

Page: 31 / 87

iRIS8 - Addressable Fire Alarm Panel
– Installer Programming
31
At the device settings screen the installer can review the general and set the additional parameter:
Input 1
Review the current status of the input:
-
ON . The input is activated.
- OFF (NORMAL State) . The input is deactivated.
- OPEN . The line connected to the input is open or no EOL module is connected to the
terminal in case the input is not used.
-
SHORT . There is a short-circuit in the line connected to the input.
Alarm
SensoIRIS MINP Gas
SensoIRIS MINP Panic
This is setting for enabling/disabling the sounders, when the input is activated. Every
pressing of the button changes the setting.
-
ENABLED . The sounders will be activated.
- DISABLED . The sounders remain silent in case of activation of the input.
3.2.8.10. Input/Output Modules
Available models:
•
SensoIRIS MIO04
– module with 4 outputs
•
SensoIRIS MIO40
– module with 4 inputs
•
SensoIRIS MIO22
– module with 2 inputs and 2 outputs
•
SensoIRIS MIO22M
– module with 2 inputs and 2 monitored outputs
•
SensoIRIS MOUT
– module with 1 output
Note: All available modules’ models have same programming parameters. The addressable SensoIRIS input/output
modules have built-in isolator module, which must be connected during installation.
For detailed description of the main screen of the device see item 3.2.6 . Press MORE button to access some additional
information or settings.
- SensoIRIS MIO04 - The module has 4 outputs, programmable for activation by an event. Press active button
with the name of the module to access the programming of the outputs.
Sounder
Group
Set a number of a sounder group
(1-127). Refer also to item
3.1.4 for more
details.
Output
1-4
Review the current status of the output:
-
ON . The output is activated.
- OFF . The output is deactivated.
Note:
The sounder group option is applicable for modules,
when to one or more of its outputs are connected
conventional sounders and the “Sounders Mode”
operation is set for the channel.
Name
Active field for entering a name for every
of the outputs.
Output
1-4
Every output can be configured as:
-
OUTPUT . Configure the operation in
menu OUTPUTS
– item
3.4 .
- ALARM. Activation in case of fire alarm
event in the system.
-
EVACUATE. Activation in case of
evacuation event in the system.
-
RESET. Activation in case of reset
command.
-
SOUNDERS MODE. Operation as an
addressable sounder. This option is useful
for applications where a conventional
sounder is connected to the output.