Installation
2004 by TELES AG Berlin, Version 2.0/iPBX8TRe/6.02, Issue: May 1998
Page 5
3 Installation
This chapter describes how to attach and configure your the TELES.iPBX 8TR
Box. The following basic steps are necessary for the installation:
1. Attach power source (section 3.1.1).
2. Connect the analog terminal devices to the TR ports (section 3.1.2).
3. Connect TELES.iPBX 8TR Box to ISDN (section 3.1.3).
4. Only for point-to-point line: change line type from the point-to-multipoint
factory setting to point-to-point (section 5.2)
Once you’ve taken these steps the box is operable and you can start making calls
right away. All incoming calls will ring at port 11 (drop port) though. Continue
then with the following settings:
5. Assign the call numbers of your ISDN line (MSN) to the individual ports
6. Check if you can hold and transfer with the attached telephones. Adapt the R
key’s flash time if necessary (section 3.2.1)
Now you can accept calls at the individual ports, and hold and transfer them.
The correct telephone number is transmitted. Next, you can adapt the
TELES.iPBX 8TR Box to special needs (e.g. different ring tones for internal and
external calls, PIN setting, external audio source, etc.).
