blue PiraT2 / 5E / 5E
User Guide
Datum: 21.09.2016
Seite 46 von 71
blue_PiraT2_UserManual_V2.4.1.doc
12 Service and safety instructions
Note according to standard EN55011:2009
The data logger is used in an industrial environment. Due to the behavior of conducted as well
as radiated disturbances it possibly can be difficult to ensure electromagnetic compatibility in
other environments.
Cleaning
The data logger should only be cleaned with a clean, slightly dampened cleaning cloth with wa-
ter. Other cleaning supplies such as petrol, alcohol etc. may not be used.
Maintenance
The data logger is maintenance-free. The customer is not allowed to open the housing. Unau-
thorized modifications will void the warranty.
Fuse
In case of an error the customer may change only the fuse on the harness or externally acces-
sible fuses. The fuse may be replaced only with a fuse of the same type and current rating.
Disposal
The disposal of the device must be in accordance to statutory provisions.
12.1 Safety advice
Installation instructions
The data logger should only be installed in the six axes.
Operating temperature
The device must not be operated outside of the specified temperature range. It is important to
ensure adequate ventilation. The data logger must not be placed too close to walls or other
equipment. The data logger must not be stacked together with other components on each other,
unless proper ventilation is ensured and the device should be used in ambient temperatures of
more than 77 °F.
Storage conditions
The data logger must be stored only in the range of - 22 °F to + 158 °F.
Condensation
The device must not be switched on directly, if it is brought from a cold environment into a room
with normal ambient conditions.
Environmental conditions
The device must not be used outdoors or in adverse environmental conditions such as mois-
ture, high humidity or dust. Furthermore, an operation of the device is not allowed in fire haz-
ardous or explosive gases.
Cable sets
When inserting the cable sets only a small effort may be applied. When you feel an increased
resistance while inserting the cable set, the correct alignment of the pins should be checked.
It may only be used the original Telemotive components. Other components such as special
cable sets have to be prepared strictly according to the pin assignment in the user guide. You
should always spare an extra fuse in the wiring harness.
