Remote Control Touch
User Guide
Datum: 08.12.2015
Seite 16 von 61
RCTouch_UserGuide_V2.1.1.doc
7.4 Installation
The RCTouch requires a connection to the power supply and one to the client. Then the
RCTouch can be used in standalone mode.
In order to make full use of all functions of the RCTouch, a connection to at least one blue PiraT
data logger is required. This creates a
T
elemotive
S
ystem
L
ink (
TSL
).
Find more information about client and TSL in the Telemotive System Client user guide.
7.4.1 Cable connection
Note:
Connect the RCTouch only with devices of Telemotive AG (blue PiraT, Remote Control).
7.4.1.1
With power supply
Note:
Make sure that the RCTouch is switched off before connecting it with a power supply or
disconnecting it.
The power connection of the RCTouch is similar to that of the Remote Control Voice.
They are NOT identical. We therefore recommend to use the device-specific cable.
The power supply can be established using the blue PiraT data logger's universal cable set or
by connecting directly to the power source.
7.4.1.1.1
Direct connection
A power cable with Lemosa connector to banana plug is required for the direct connection of the
RCTouch to the power supply.
Figure 7.4: Power cable with Lemosa connector to banana plug