R305 AT Commands
©2011 Telegesis (UK) Ltd
- 29 -
AT Command Manual (Rev 3.05)
+SR
– Set Source Route to Remote Device
Execute Command
AT+SR:<NodeID>,<NodeID>,…
Set the source route of a message sent to a
remote device, starting with the NodeID of
the remote device followed by all NodeIDs on
the route from the remote node to the local
node
Use on
All Devices
Note: Setting up invalid routes may lead to
listed devices becoming unavailable. To
confirm a route use AT+FNDSR.
Response
OK
or
ERROR<errorcode>
<errorcode> represents the error code explained in
section 3.
Stores route information for up to 30 hops which
will be used when sending any message to a
remote node, which is part of the listed devices.
SW release
R300
+FNDSR
– Find the Source Route to a remote device
Execute Command
AT+FNDSR:<address>
Where <address> can be the remote node‟s
EUI64 or address table index
Tries to find source route information to the
specified device by sending a ZDO request
to the remote device and thus triggering a
reply.
Use on
Sink, COO
Use on
A Sink
Response
OK
or
ERROR<errorcode>
Prompt
SR:XX,<EUI64>,<NodeID>,<NodeID>…
Where XX represents the number of hops to the
remote node, EUI64 its EUI64 number followed by
a list of NodeIDs starting with the remote node
listing all nodes along the path to the local node
<errorcode> represents the error code explained in
section 3.
SW release
R302