Live Preview Introduction
DVR User Manual
30
Add Scheme
Click
in area to create a new scheme.0 Click
on the top right corner of the
scheme to delete it.
Configure Scheme
a) Select a scheme in area and then click the screen mode button on the tool bar to set the
screen mode of the scheme.
b) Select a camera window in area and then double click the camera in area . The camera
will be added into the selected window. One camera in the same scheme cannot repeat. You can
click the right-click menu “Clear” in area to remove a single camera or click
to remove
all the cameras.
c)
Click “Apply” to save the settings.
Start Sequence View
Go to live preview interface and then click
to pop up a window. Set the dwell time in the
window and then click
to start scheme view in sequence. Double click the sequence view
interface to pause the view; double click again to restore the view. Click
to stop the view.
5.2.4 Spot View
Click Start
Settings
System
Basic
Output Settings
Output 2 to go to the interface as
shown below.
Click
on the left to create a new scheme. Each scheme can only add one analog camera.
Select a scheme on the left and then double click or drag a camera on the right to the scheme
window in the middle of the interface. After finishing the settings of all the schemes, select the
dwell time and click “Apply” to start playing the schemes in sequence in output 2.
Summary of Contents for JN6300-S
Page 108: ...FAQ DVR User Manual 102 Fig 9 2...
