Teledyne TS-C2500, User Manual, Page: 78 / 191

76

Operational Reference Genie_TS_Series GigE Vision Camera
Line 4 Trigger Line4 Start Timer on a transition of I/O Line 4 event.
Timer 1 End Timer1End Start Timer on Timer End event.
Counter 1 End Counter1End Start Timer on Counter 1 End event.
Timer Line Activation timerStartLineActivation Select the trigger activation mode which starts the
timer.
Rising Edge RisingEdge Starts counter on rising edge of the selected signal.
Falling Edge FallingEdge Starts counter on falling edge of the selected signal.
Any Edge AnyEdge Starts counter on the falling or rising edge of the
selected signal.
1.00
Expert
DFNC
Timer Delay timerDelay Sets the duration (in microseconds) of the delay to
apply at the reception of a trigger before starting the
timer.
1.00
Expert
DFNC
Timer Duration timerDuration Sets the duration (in microseconds) of the timer
pulse.
1.00
Expert
DFNC
Timer Value timerValue Reads or writes the current value (in microseconds)
of the selected timer. Writing to this feature is
typically used to set the timer start value.
1.00
Expert
DFNC
Timer Reset timerReset Resets the timer to 0 while timerStatus=TimerActive .
Else the timer resets to 0 on the next
timerStartSource event. (WO)
1.00
Expert
DFNC
Counter and Timer Group Block Diagram