Teledyne T300, Operation Manual, Page: 85 / 426

Teledyne API – Model T300/T300M CO Analyzer Getting Started
83
S
ET
CO S
PAN
G
AS
C
ONCENTRATION
Set the expected CO pan gas concentration. This should be 80-90% of range of
concentration range for which the analyzer’s analog output range is set.
M-P CAL CO SPAN CONC:40.0 Conc
0 0 4 0 .0 0 ENTR EXIT
SAMPLE GAS TO CAL:CO
CO O2 ENTR EXIT
SAMPLE RANGE=50.0 PPM CO= XX.XX
<TST TST> CAL SETUP
M-P CAL RANGE=50.0 PPM CO= XX.XX
<TST TST> ZERO SPAN CONC EXIT
SAMPLE RANGE TO CAL:LOW
LOW HIGH ENTR EXIT
The CO span concentration value is
automatically default to
40.0 PPM.
If this is not the the concentration of
the span gas being used, toggle
these buttons to set the correct
concentration of the CO
calibration gas.
EXIT ignores the new
setting and returns to
the previous display.
ENTR accepts the new
setting and returns to
the
CONCENTRATION
MENU.
Only appears if either
the optional O2 or CO2
sensors are installed.
Only appears if the
analyzer is set for DUAL
range (LOW/HIGH) mode
06864B DCN6314