Teledyne T300, Operation Manual, Page: 123 / 426

Teledyne API – Model T300/T300M CO Analyzer Setup Menu
121
To access the ANALOG I/O CONFIGURATION submenu, press:
DIAG AIO TEST_OUTPUT: 5V,OVR, NOCAL
<SET SET> EDIT EXIT
SAMPLE RANGE=50.0 PPM CO= XX.XX
<TST TST> CAL SETUP
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE EXIT
SETUP X.X SECONDARY SETUP MENU
COMM VARS DIAG EXIT
SETUP X.X ENTER PASSWORD:818
8 1 8 ENTR EXIT
AIO Configuration Submenu
DIAG SIGNAL I/O
NEXT ENTR EXIT
Continue pressing NEXT until ...
DIAG ANALOG I/O CONFIGURATION
PREV NEXT ENTR EXIT
DIAG AIO A OUTS CALIBRATED: NO
<SET SET> CAL EXIT
DIAG AIO CONC_OUT_1: 5V, OVR, NOCAL
<SET SET> EDIT EXIT
DIAG AIO CONC_OUT_2: 5V, OVR, NOCAL
<SET SET> EDIT EXIT
Toggle these
buttons to enter
the correct
PASSWORD.
Adjusts the signal output
for Analog Output A1.
Adjusts the signal output
for Analog Output A2.
DIAG AIO AIN CALIBRATED: NO
<SET SET> CAL EXIT
DIAG AIO XIN1:1.00,0.00,V,OFF
<SET SET> EDIT EXIT
SET> scrolls to XIN2 through XIN8
Figure 5-3: Accessing the Analog I/O Configuration Submenus
06864B DCN6314