Teledyne T300, Operation Manual, Page: 100 / 426

Setup Menu Teledyne API – Model T300/T300M CO Analyzer
98
5.2.
SETUP
à
ACAL: AUTOMATIC CALIBRATION
Instruments with one of the internal valve options installed can be set to automatically
run calibration procedures and calibration checks. These automatic procedures are
programmed using the submenus and functions found under the
ACAL menu.
A menu tree showing the ACAL menu’s entire structure can be found in Appendix A-1
of this manual.
Instructions for using the ACAL feature are located in the Section 9.4 of this manual
along with all other information related to calibrating the T300/T300M Analyzer.
SETUP X.X PRIMARY SETUP MENU
CFG ACAL DAS RANG PASS CLK MORE EXIT
SAMPLE RANGE=50.00 PPM CO= XX.XX
<TST TST> CAL SETUP
Accesses AutoCal setup menus
5.3.
SETUP
à
DAS: INTERNAL DATA ACQUISITION SYSTEM
Use the SETUP>DAS menu to capture and record data. Refer to Section 7 for
configuration and operation details.
5.4.
SETUP
à
RNGE: ANALOG OUTPUT REPORTING RANGE
CONFIGURATION
Use the SETUP>RNGE menu to configure output reporting ranges, including scaled
reporting ranges to handle data resolution challenges. This section also describes
configuration for Single, Dual, and Auto Range modes.
5.4.1. ANALOG OUTPUT RANGES FOR CO CONCENTRATION
The analyzer has several active analog output signals, accessible through the ANALOG
OUT connector on the rear panel.
06864B DCN6314