Teledyne T100, Instruction Manual, Page: 73 / 404

Teledyne ML - T100 UV Fluorescence SO2 Analyzer
Getting Started
73
3.7.1.2. DILUTION RATIO SETUP
If the dilution ratio option is enabled on your T100 and your application involves
diluting the sample gas before it enters the analyzer, set the dilution ration as follows:
EXAMPLE
SAMPLE RANGE=500.0 PPB SO2= XXXX
<TST TST> CAL SETUP
SETUP PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE EXIT
SETUP RANGE CONTROL MENU
UNIT DIL EXIT
SETUP CO DIL FACTOR:1.0 Gain
0 0 0 0 1 .0 ENTR EXIT
SETUP CO DIL FACTOR 20.0 Gain
0 0 0 2 0 .0 ENTR EXIT
Toggle these buttons to
set the dilution factor.
This is the number by
which the analyzer will
multiply the SO
2
concentration of the gas
passing through the
reaction cell.
EXIT ignores the
new setting.
ENTR accepts the
new setting.
SETUP CO2 DIL FACTOR:1.0 Gain
0 0 0 0 1 .0 ENTR EXIT
SETUP O2 DIL FACTOR:1.0 Gain
0 0 0 0 1 .0 ENTR EXIT
Only appears if the
optional CO
2
sensor
is installed.
Only appears if the
optional O
2
sensor
is installed.
Figure 3-26: Dilution Ratio Setup