Teledyne T100, Instruction Manual, Page: 116 / 404

Operating Instructions Teledyne ML - T100 UV Fluorescence SO2 Analyzer
116
4.8.4.6. AIN CALIBRATION
This is the sub-menu to conduct the analog input calibration. This calibration should
only be necessary after major repair such as a replacement of CPU, motherboard or
power supplies. Navigate to the
ANALOG I/O CONFIGURATION MENU from the
DIAG Menu (refer to Figure 4-17), then press:
Exit at any time to
return to the main
DIAG menu
DIAG ANALOG I / O CONFIGURATION
PREV NEXT ENTR EXIT
Continue pressing SET>
until …
DIAG AIO AIN CALIBRATED: NO
< SET
SET> CAL EXIT
DIAG AIO AIN CALIBRATED: YES
< SET
SET> CAL EXIT
Instrument
calibrates
automatically
Exit to return to the
ANALOG I/O
CONFIGURATION
MENU
DIAG AIO CALIBRATING A/D ZERO
CALIBRATING A/D SPAN
Figure 4-29: DIAG
– Analog Output – AIN Calibration
4.8.4.7.
ANALOG INPUTS (XIN1…XIN8) OPTION CONFIGURATION
To configure the analyzer’
optional analog inputs define for each channel :

gain (number of units represented by 1 volt)

offset (volts)

engineering units to be represented in volts (each press of the touchscreen button scrolls the
list of alphanumeric characters from A-Z and 0-9)

whether to display the channel in the Test functions