Teledyne T100, Instruction Manual, Page: 107 / 404

Teledyne ML - T100 UV Fluorescence SO2 Analyzer Operating Instructions
107
4.8.4.1. ANALOG OUTPUT SIGNAL TYPE AND RANGE SPAN SELECTION
To select an output signal type (DC Voltage or current) and level for one output channel,
activate the
ANALOG I/O CONFIGURATION MENU from the DIAG Menu (refer
to Figure 4-17), then press:
DIAG AIO CONC_OUT_1 RANGE: 5V
SET> EDIT EXIT
DIAG ANALOG I / O CONFIGURATION
PREV NEXT ENTR EXIT
DIAG AIO AOUTS CALIBRATED: NO
< SET SET> CAL EXIT
DIAG AIO CONC_OUT_1 RANGE: 5V
0.1V 1V 5V 10V CURR ENTR EXIT
These buttons set
the signal level
and type for the
selected channel
DIAG AIO CONC_OUT_1:5V,OVR,CAL
< SET SET> EDIT EXIT
Press SET> to select the
analog output channel to be
configured. Press
EDIT to
continue
Pressing ENTR records the new setting
and returns to the previous menu.
Pressing EXIT ignores the new setting and
returns to the previous menu.
DIAG AIO CONC_OUT_1 RANGE: 10V
0.1V 1V 5V 10V CURR ENTR EXIT
Figure 4-20: DIAG
– Analog I/O Configuration Menu