Teledyne Sierra M6-2, User Manual, Page: 70 / 538

Teledyne LeCroy Projects
68 Sierra M6 ‐ 2 SAS/SATA Protocol Analyzer User Manual
When you check this box, the Primitive category appears in the Parameter window, and
the window enables the Exclude Idle checkbox.
Figure 2.43: SAS: Exclude Patterns Checked
SAS vs. SATA: SATA Dialog replaces “Exclude SATA_CONT” with “Exclude CONT” and
“Exclude SATA_SYNC” with “Exclude SYNC”. SATA Dialog has “ Exclude Dev Slp Packets”.
SATA Dialog has different Pattern Parameters (see
“Patterns and Data Capture Setup” on
page 66 ).
To remove an item from capture, highlight it in the Project tree and click the <<Remove
button.
2.6.7 Pre and Post Trigger Data Capture
You can define one set of patterns for capture prior to the occurrence of a trigger and
another set of patterns for capture after the occurrence of a trigger. The selection and
setup procedure is the same for both Pre
‐ Trigger capture and Post ‐ Trigger capture.
Check Define different patterns for pre ‐ trigger and post ‐ trigger data capture to enable
the Pre ‐ Trigger Capture and Post ‐ Trigger Capture tabs (instead of only the Capture tab).
See the following figure.