Teledyne Sierra M6-2, User Manual, Page: 474 / 538

Teledyne LeCroy Sierra Trainer Generation Commands
472 Sierra M6 ‐ 2 SAS/SATA Protocol Analyzer User Manual
@varName1 = COUNT_REC_RESOURCE_OUTPUT_A
@varName1 = COUNT_REC_RESOURCE_OUTPUT_B
@varName1 = COUNT_REC_RESOURCE_OUTPUT_C
@varName1 = COUNT_REC_RESOURCE_OUTPUT_D
@varName1 = COUNT_REC_RESOURCE_OUTPUT_E
@varName1 = COUNT_REC_RESOURCE_OUTPUT_F
Syntax for clearing (resetting) counters is:
CLEAR_REC_RESOURCE_OUTPUT_A
CLEAR_REC_RESOURCE_OUTPUT_B
CLEAR_REC_RESOURCE_OUTPUT_C
CLEAR_REC_RESOURCE_OUTPUT_D
CLEAR_REC_RESOURCE_OUTPUT_E
CLEAR_REC_RESOURCE_OUTPUT_F
Example:
CLEAR_REC_RESOURCE_OUTPUT_A
While(@Counter < MaxPrimitiveCount) {
… @Counter = COUNT_REC_RESOURCE_OUTPUT_A … }
5.13.8 Procedure Definition
Procedures allow creating simple syntaxes for complex reusable parts in scripts. You can
write such code once as a procedure and use everywhere required.
Procedure definition syntax is:
procedure procedureName
{
...
}
Calling procedure syntax is:
Call procedureName
5.14 Sierra Trainer Generation Commands
5.14.1 General Commands
IDLE (n) Generator will insert n idle
DWORD
s into the
generation stream.
CLEAR_CREDIT_AVAIL This commands clears the credit
established with the command
WF_CREDIT_AVAIL. (See WF_CREDIT_AVAIL
in following section on Wait Commands for
explanation).
RD_ERROR Generator will insert one idle
DWORD
into
the generation stream, which will
intentionally break RD sequence creating
RD error.