Teledyne Sierra M6-2, User Manual, Page: 439 / 538

Sierra M6 ‐ 2 SAS/SATA Protocol Analyzer User Manual 437
Sierra Trainer Menus Teledyne LeCroy
configuration in both of them. See “Ports Configuration” on page 112 . The following
describes possible configurations:

Analyzer and Trainer on same port : You can generate initiator/target traffic
and also capture the traffic generated.

Analyzer and Trainer on same port, and Analyzer and Trainer on another
port : You can generate initiator/target traffic and also capture the traffic gen ‐
erated on two ports.

Trainer on one port, and Analyzer on another port : Trainer is run on a port
generating initiator/target traffic and Analyzer is run on the other port cap ‐
turing the traffic.

Trainer and Jammer on same port : You can generate initiator/target traffic
and also inject errors on the traffic between initiator and target on the port.
Note:
See “Multi ‐ Port Trainer Script Assignments to Links” on page 455 .
Display Options: Selects what information to display. See “Display Options” on page 510 .
Figure 5.3: Trainer Setup Menu.
5.1.3 Generate Menu
Start Generation: Causes the Generator to begin generation.
Stop Generation: Causes the Generator to stop generation.
Resume Generation: Causes the Generator to resume generation after a stop.
Connect Link: Automatically bring the linkup to the Host, Device, Initiator, or Target
connected to the Generator.
Disconnect Link: Disconnect link.
Connect Parameters: Set the “Identify” frame parameter settings to keep the link
connected. See “Connection Parameters” on page 515 .
Generation Options: Setup the Generation Rules. See “Auto Speed Negotiation” on page
497 .