Teledyne Sierra M6-2, User Manual, Page: 390 / 538

Teledyne LeCroy Scenario Events
388 Sierra M6 ‐ 2 SAS/SATA Protocol Analyzer User Manual
When you create a DWORD match, keep the following in mind:

The pattern can be inside or outside of frames (it does not matter if the pattern
is inside a frame or not).

Because the pattern can be inside or outside of frames, there is no offset.

You can make user ‐ defined primitives. (This is the reason this feature was cre ‐
ated.)

You can use any K/D pattern.
4.7.2 Address Frame
With Infusion, you must enter all values in reverse MSB, LSB order.
For example: a SAS Address in the viewer "5000C50056B8C829" should be entered like
this in Infusion: "29C8B85600C50050".
4.7.3 SAS Data Pattern
When you create a SAS data pattern, keep the following in mind:

The pattern must be defined inside a frame that starts with a SOF or SOAF.

The pattern must be data only (no K ‐ codes/primitives).

The pattern must be defined at a specific offset in the frame.

The pattern and mask must be specified in the same format as specified in the
SAS standard:
0x12345678 (hex)
where “1” is the first digit on the cable and is the MSB as given in the SAS Stan
‐
dard.
For example, for an SMP Request:
Pattern: 0x40000000
Mask: 0xFF000000
Offset: 0
SOF Type: SOF
4.7.4 SATA Data Pattern
When you create a SATA data pattern, keep the following in mind:

The pattern must be defined inside a frame that starts with a SATA_SOF.

The pattern must be data only (no K ‐ codes/primitives).

The pattern must be defined at a specific offset in the frame.

The pattern and mask must be specified in the same format as specified in the
SATA Standard.