Teledyne Sierra M6-2, User Manual, Page: 164 / 538

Teledyne LeCroy Emulation
162 Sierra M6 ‐ 2 SAS/SATA Protocol Analyzer User Manual
Figure 2.172: SAS: PHY Setting Dialog
Select the port speed settings (see “PHY Setting Dialog” on page 136 ).
After you click OK , you can Enable Muxing On .
Pattern Generator
You can select a Pattern Generation file.
Initiator Emulator
You can run an Initiator Emulator while setting:

Auto stop Exerciser when Analyzer stopped

Auto stop Analyzer when Exerciser stopped

Auto update “Sector Count/Transfer Len” before running

SAS Address

Data Frame Payload Size

Frame Receive Timeout

Logical Block Size

ATA Command Execution Timeout

Send NOTIFY ENABLE SPINUP primitive
Check Autostop Exerciser when Analyzer Stopped to halt the Initiator Emulator when
the Analyzer stops. If unchecked, the Exerciser continues to run even after the Analyzer
stops.
Check Autostop Analyzer when Exerciser Stopped to halt the Initiator Emulator when
the Exerciser stops. If unchecked, the Exerciser continues to run even after the Exerciser
stops.