Teledyne SeaBat T Series, Operator'S Manual, Page: 89 / 152

TROUBLESHOOTING
SeaBat T-Series Subsea Operator's Manual Page 77 January 31, 2019
Version 7
Message Description Action
Error creating non-sonar data
reader thread BITE module has failed to
initialize. Check Windows
installation and
resources.
Failed to allocate memory for
ADMXRC read
Failed to allocate memory for
ADMXRC transfer
The software could not
allocate enough system
memory to perform the
operation. Make sure no other
software is running on
the sonar processor.
Reboot the system.
Failed to set up DMA Card 0
Failed to set up DMA Card 1
The software could not
access the processing card
device. Check ADMXRC
drivers.
Internal 7k Center error
Internal error, 7kCenter NOT fully
operational
One or more startup
conditions have failed. Check previous alarms
or warnings and verify
software installation.
Inbound memory initialization failed
MMF Outbound memory creation
…
PC resources are
inadequate. Check RAM or virtual
memory resources
Required file: "7k_0.xml" or
"7k.xml" Not found.
Required file: "7k_Bite.htm" Not
found.
SET UP: FAILED TO LOAD BIT
FILE "XXX" for Device <x>,
Enumerator <x>
A critical startup configuration
file was missing. Reinstall the software.
Socket initialization failed, error
code <x> Windows has failed to
allocate a network resource. Check network
permissions and
resources or Reinstall
operating system.
A.2.2 PCI Card Related (ADMXRC) Errors
The ADMXRC refers to the drivers that control the main processing unit within the sonar
processor. This processing card sits on the motherboards PCI bus and acts as a signal
processing layer between the hardware and software.
Message Description Action
2nd ADMXRC card not found
ADMXRC card not found, ERROR
=
ADMXRC.dll not found.
Configure FPGA failed.
Incorrect ADMXRC board found,
card_1
One or more of the
processing cards has failed
to initialize or is non-
functional within the sonar
processor. Reboot sonar processor
and try again.