Teledyne Princeton Instruments PI-MTE, System Manual

Page: 92 / 118

92 PI-MTE System Manual Issue 6
A.1.3 Power
Maximum internal heat dissipation in watts: 90
A.1.4 Cooling
• –40°C with in-vacuum operation and circulating coolant at +15°C
• –25°C with the visible nose and circulating coolant at +15°C.
A.2 ST-133
ST-133A Dimensions: 5.25 in (13.34 cm) width; 13.63 in (34.62 cm) length; 8.75 in
(22.23 cm) height; 13 lb (5.9 kg) weight
ST-133B Dimensions: 5.80 in (14.72 cm) width; 13.91 in (35.33 cm) length; 8.59 in
(21.82 cm) height; 12.5 lb (5.7 kg) weight
A.2.1 Connectors
EXT SYNC: TTL input (BNC) to allow data acquisition to be synchronized with external
events. Sense can be positive or negative going as set in software. Refer to
Chapter 6,
Advanced Topics , on page 59 for information about Synchronization and Trigger
Modes.
SCAN: TTL output (BNC) for monitoring camera status. TTL low when array is being
read; otherwise high.
READY: TTL output (BNC); marks start of first exposure. When run is initiated, remains
high until completion of cleaning cycles preceding first exposure, then goes low and
remains low for duration of run.
Detector Interface: female, D-sub-miniature 25-pin connector for communication and
data transfer between the controller and the detector. Provides power to detector.
TTL In/Out: male, D-sub-miniature 25-pin connector; 8 TTL inputs; 8 TTL outputs
• TTL Input: external sync
• TTL Output: (ready) frame start; (scan) shutter/readout status
• TTL Requirements: Rise time
≤
40 nsec, Duration
≥
100 nsec.
AUX BNC Connector: Not currently activate. Reserved for future use
Serial Com Interface: female, D-sub-miniature 9-pin connector for RS232 serial
communication
A.2.2 Power
Power Input: 100, 120, 220, 240 V; 47 to 63 Hz. Power to detector is provided through
the Detector-Controller cable.
Power Consumption: Refer to the Fuse/Voltage label on the back of the ST-133.
A.2.3 Miscellaneous
Readout Bits/Pixel
• 1300B: 16 bits @ 50 kHz to 2 MHz
• 2048B: 16 bits @ 50 kHz to 1 MHz