Teledyne Princeton Instruments Lansis, System Manual

Page: 18 / 101

18 Lansis
®
System Manual Issue 1
EAR99 Technology Subject to Restrictions Contained on the Cover Page.
2.1.5 Rear-Panel Connectors and Indicators
Figure 2-4 illustrates the rear-panel connectors and indicators on a Lansis camera.
Figure 2-4: Lansis Rear-Panel Connectors and Indicators
Refer to Table 2-1 for information about each rear-panel connector and indicator.
Table 2-1: Lansis Rear-Panel Connectors and Indicators
Label Description
USB3 Control signals and data are transmitted between the camera and host computer
via this port.
TRIGGER
IN
0 – +5.0 V
DC
TTL-compatible logic level input with a 10 k

pull-up resistor. Allows
data acquisition and readout to be synchronized with external events.
Positive or negative edge triggering is programmable.
CAUTION: Do not apply a voltage greater than +5.0 V
DC
or less than 0 V
DC
(i.e., a
negative voltage,) to this input. Doing so may permanently damage
the Lansis camera.
OUT1 0 to +5.0 V
DC
programmable TTL-compatible logic level output. This output can
be programmed and inverted via the application software
OUT2 0 to +5.0 V
DC
programmable TTL-compatible logic level output. This output can
be programmed and inverted via the application software.
POWER Power input from external power supply provided with the Lansis system.
STATUS This LED indicates the state of the camera. See Table 2-2 to decode the camera
state.
441
1-0
174_
0
00
3