Teledyne Oldham MX 16, User Manual

Page: 34 / 60

MX 16
ANALOG AND DIGITAL CONTROLLER
USER GUIDE
30 NP16EN
Revision: A.0
■
The controller no longer keeps account of inputs (detectors, logic inputs).
■
The simulation measurements/status are initialized to the current measurement/status values.
The relays, the internal buzzer, and the analog outputs remain in their current status.
■
The screens, management of relays, outputs, etc. are those of Normal operation.
■
The internal relay and the common default LED are activated.
■
To change the value of a detector, use the  keys to increase or decrease the measurement
value simulated from –15% to 115%. For a logic input, use the  keys to select the input,
 to select
Alarm or Alarm Off.
■
The banner of alarms does not appear.
■
The events log indicates
Begin Simulation and End Simulation.
■
Exit the simulation mode by pressing the End simul key. Automatic release then occurs and
resets the average values to zero. The current measurements are displayed once more.
5. Information
1. Detectors
This displays the main information on the detector (type, range, detected gas).
2. Events
Figure 22: Example of gas alarm records
1. Alarm events
This displays, for each of the detectors concerned: detector ID, alarm type (Al1, Al2, Al3, Al1mean,
Al2mean, Al3mean, OVS), status (activated = ON or deactivated = OFF) as well as the date and
time of occurrence or of the release.
The letter “S” appears on the line if the events were obtained when the
MX 16 was in simulation
mode
Delete deletes all the data. Up to 512 events can be memorized. Beyond that, the most recent
event deletes the oldest.
Previous page, Next page, and Last page access the corresponding pages of the file.
Message Significance
AL1 Detector in level 1 alarm