Teledyne Oldham MX 16, User Manual

Page: 30 / 60

MX 16
ANALOG AND DIGITAL CONTROLLER
USER GUIDE
26 NP16EN
Revision: A.0
■
4. Display
settings
Scrolling display
■
OFF: the display is frozen on a selected detector.
By zone
■
OFF: displays all connected detectors regardless the zone they are
assigned to.
Screen saver
■
OFF: no screen saver.
■
ON: turns into the screen saver mode (displays TELEDYNE OLDHAM
SIMTRONICS logo) if no key is pressed for a certain period of time.
■
5. Language Selection of the display menu language.
2. Program
■
1. Buzzer
On/Off
Activates or deactivates the internal buzzer of the
MX 16.
■
2. Tag set Allows for the modification of detector tags previously programmed (in
factory).
■
3. Alarm
settings
Allows for the modification of detector alarms previously programmed in
factory
■
4. Port RS485 Configuration of Port RS485 (speed, parity, stop bits, slave number). This
configuration is only useful if the
MX 16 is equipped with the RS485
communication card.
3. Calibration
If the measurement cell has changed, it is important to declare this through a menu
no.
5 Cell change.
1. Detector select.
This menu enables the selection of detectors to be calibrated (calibration from
MX 16 or on the
detector).
A. Display of information described in factory: i.e., measurement range, gas detected, current
detector ID and its type.
B. Display for the current detector:
■
Last passed calibration: Date and time of the last calibration carried out and completed.
■
Last sensor replacement: Date and time of last cell change.
■
Wear rate: Relation between the value of the standard gas and the value read (sensitivity
measurement). A wear rate in excess of 100% entails a sensor replacement.