Teledyne Linea GigE 2K, User Manual

Page: 104 / 132

102
•
Technical Specifications Linea GigE Series Camera
Additional Notes on Linea GigE Identification and
Mechanical
Identification Label
Linea GigE cameras have an identification label applied to the back side, with the following information:
Model Part number
Serial number
MAC ID
2D Barcode
CE and FCC logo
“Made in Canada” Statement
Additional Mechanical Notes
Linea GigE supports a screw lock Ethernet cable (see Ruggedized RJ45 Ethernet Cables).
For information on lens requirements see Lens Selection Overview and Optical Considerations.
Each camera side has two mounting holes in identical locations, which provide good grounding capabilities.
Overall height or width tolerance is ± 0.05mm.
Sensor Alignment Specification
The following figure specifies sensor alignment for Linea GigE where all specifications define the
absolute maximum tolerance allowed for production cameras. Dimensions "x, y, z", are in microns
and referenced to the Linea GigE mechanical body or the optical focal plane (for the z-axis
dimension). Theta specifies the sensor rotation relative to the sensor's center and camera
mechanical.
(+/
-)
Y
variance
(+/-) X variance
Sensor Alignment Reference
Z variance not shown
(+/-) theta variance
Linea GigE
X variance
± 300 µm
Y variance
± 300 µm
Z variance
± 300 µm
Theta variance
± 0.3°