Teledyne Deltaflow DF180, Operation And Maintenance Manual, Page: 21 / 42

January, 2018
Page 21
Instantaneous (updated every 5 seconds) and 1-minute values shown above are stored in three 16 bit
Modbus registers. The first 2 registers contain a floating point number for the parameter. The 3
rd
word
contains a status word with the individual bits define as follows (bit 0 is the least significant bit):
bit #
15
- not used
14 - In interference test
13 - Interference test failure
12 - Full scale exceeded
11 - not used
10 - In Calibration
9 - fatal fault
8 - non-fatal fault
7 - not used
6 - In Maintenance
5 - not used
4 - Communication Failure
3 - not used
2 - Data valid
1 - In Span Calibration
0 - In Zero Calibration
4.1.5 Data: Tools
This screen provides information on firmware version, IP address, and communication status.
Occasionally the configuration on the Deltaflow controller and what is shown on the web interface may