Teledyne ADFM Hot Tap, Installation And Operation Manual, Page: 12 / 116

ADFM® Flow Meter
Section 1 Introduction
1-2
1.2 Initial Inspection
Upon receipt, inspect the shipping container for any damage. If
the shipping container or packing material shows signs of
damage, it should be retained until the contents have been
inspected for completeness and the system has been checked
both mechanically and electrically. If the contents are incomplete
or damaged, or if the system indicates a failure in some com-
ponent during initial testing, notify Teledyne Isco as soon as pos-
sible, and notify the carrier regarding any damage to the
shipping container and packing material.
Contact Information Technical assistance for the ADFM flow meter can be obtained
from:
Teledyne Isco
4700 Superior St.
Lincoln NE 68504
Phone: (866) 298-6174 or (402) 464-0231
Fax: (402) 465-3022
E-mail: IscoService@teledyne.com
1.3 Technical
Specifications
The following tables provide technical specifications for the
ADFM box and cylindrical electronics controllers, and for the
Pro20 open channel and Hot Tap Insertion velocity sensors.
Table 1-1 Technical Specifications: ADFM Controller
Physical
Electronics Unit Enclosures Wall or console-mounted box, or cylindrical canister
Operating Temperature -15 to 125 °F (-26 to 52 °C)
Storage Temperature -65 to 160 °F (-54 to 71 °C)
Packaging
Box
Canister NEMA 4X (IP66)
NEMA 6P (IP68)
Dimensions
Box
Canister 17.5 x 14.8 x 6.7 in. (445 x 375 x 170 mm)
28.5 x 10 in. (724 x 254 mm)
Weight
Box
Canister 24 lbs (11 kg)
36 lbs (16 kg)
Measurement Performance
Flow
Accuracy 2% of reading in typical conditions
Velocity
Maximum Velocity ±30.0 ft/s (± 9m/s)
Velocity Bin Size 2 to 12 inches (50 to 3000 mm) - user selectable