10.4.3.1
Global parameters
The global parameters are shown in the bottom right corner of the screen, below the
Ac-
tive measurements
section.
To change the global parameters, follow this procedure:
1. In the bottom right corner of the screen, click to select the parameter to change.
2. Change the parameter to the desired value, and then press Enter or click anywhere
on the screen.
3. To reset the global parameters to the default values provided by FLIR, click
Reset
.
10.4.3.2
Local parameters
The local parameter settings override the global values. To change the local parameters,
follow this procedure:
1. In the
Active measurements
section, click
Settings
next to the tool for which
you want to change the parameters. The
Settings
dialog box appears.
2. To activate the use of local parameters, select the
Local parameters
check box. The
values for the
Emissivity
,
Reflected
temperature, and
Distance
parameters are now
editable.
3. To deactivate the use of local parameters, deselect the
Local parameters
check box.
4. When completed, click
Save changes
.
10.4.4
Working with image modes
The camera captures both thermal and visual images at the same time. By your choice
of image mode, you select which type of image to display on the screen.
The camera supports the following image modes:
•
Thermal
: The camera displays a fully thermal image.
•
MSX
(Multi Spectral Dynamic Imaging): The camera displays the thermal image
where details from the visual image have been added.
#T810579; r. AB/78918/78918; en-US
24
