Teledyne 200E, Instruction Manual, Page: 73 / 302

Operating Instructions Model 200E Instruction Manual
To access the DIAG functions press the following keys:
SETUP X.X ENTER DIAG PASS: 818
8 1 8 ENTR EXIT
SETUP X.X
PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE EXIT
SETUP X.X
SECONDARY SETUP MENU
COMM VARS DIAG EXIT
From this point
forward, EXIT returns
to the
SECONDARY
SETUP MENU
DIAG SIGNAL I / O
NEXT ENTR EXIT
DIAG ANALOG OUTPUT
PREV NEXT ENTR EXIT
DIAG ANALOG I / O CONFIGURATION
PREV NEXT ENTR EXIT
DIAG TEST CHAN OUTPUT
PREV NEXT ENTR EXIT
DIAG ELECTRICAL TEST
PREV NEXT ENTR EXIT
DIAG OZONE GEN OVERRIDE
PREV NEXT ENTR EXIT
EXIT returns
to the main
SAMPLE
display
DIAG OPTIC TEST
PREV NEXT ENTR EXIT
DIAG FLOW CALIBRATION
PREV NEXT ENTR EXIT
SAMPLE RANGE = 500.0 PPB NOX=X.X
< TST TST > CAL SETUP
EXIT returns
to the
PRIMARY
SETUP MENU
6.7.1. Signal I/O
The signal I/O diagnostic mode allows to review and change the digital and analog
input/output functions of the analyzer. See Appendix A-4 for a complete list of the
parameters available for review under this menu.
NOTE
Any changes of signal I/O settings will remain in effect only until the signal I/O
menu is exited. Exceptions are the ozone generator override and the flow sensor
calibration, which remain as entered when exiting.
58 044100102 Rev A