TELEDYNE OLDHAM SIMTRONICS Everywhereyoulook MultiFlame DF-TV7, Operating Manual

Page: 22 / 64

MULTIFLAME DF-TV7
OPTICAL FLAME DETECTOR
OPERATING MANUAL
16 NOSP17662
Revision 03
4.2 Mounting
Use the two 7 mm diameter holes and the half-slotted hole to secure the support.
It is highly recommended to install the support with cable-gland downward in order to avoid
water infiltrations. In case of horizontal position, it is advised to make one or two loops with the
cable at the entry of the cable-gland.
When mounting the cable gland (sold separately), if no tightening torque is specified by the
manufacturer, consider than a tightening torque of 20N.m +/-10% is the most suitable.
Figure 3 : Drilling dimensions for support fixing.
4.2.1 Multi-position support
4.2.1.1 Multi-position wall mount bracket AS054
In this configuration, the support is made by
two brackets connected each other by two
CHC M6 screws.
The main bracket is fixed on the wall,
allowing the detector to be in horizontal
position, perpendicular to the wall. The
vertical angle is adjusted using one of the 4
top holes of bracket.