TELEDYNE OLDHAM SIMTRONICS Everywhereyoulook DG-TT7-K, Operating Manual

Page: 43 / 72

MULTIXPLO AND MULTITOX DETECTORS
OPERATING MANUAL
NOSP17665
Revision 02a
37
Mode screen
The first line shows the operating mode of the sensor in the network (logic link test/out of
order/emulation).
The second line shows if the network part of the detector is “operating” or “out of order”. For any
further details, please refer to the Syntel system operating manuals.
Network screen: alim
Information displayed:
•
Voltage A: ON / OFF
•
Voltage B: ON / OFF
For any further details, please refer to the Syntel system operating manuals
6.7.3.4 [INH] screen
This screen is dedicated to verify the inhibition mode configuration (frozen or free). If the
access level permits it, it is possible to change this setting.
6.8 Adjustment menu [ADJT]
This menu presents all the detector settings. All the functionalities, except alarm level
acknowledgment, request access level 2.
6.8.1 [STAT]us sub-menu
6.8.1.1 Alarm Acknowledgement
This menu enables the acknowledgement of the memorized alarms. The alarm can be
acknowledged only if the alarm condition has disappeared.
6.8.1.2 Inhibition / End of inhibition
The inhibition (called permanent inhibition) is activated or deactivated manually using the menu.
This function is used for deactivating the detector outputs (example: during maintenance).
The « inhibition » menu is available if the sensor is not in inhibition, maintenance inhibition or
simulation.
Selecting the inhibition mode will switch the detector in inhibition mode.
The message “End of inhibition” is displayed on the TLU.
Press on “End of inhibition” to get the detector back to normal operating mode.