Page 17
Telect, Inc. • USA +1.509.926.6000 • 52.33.3836.37.52
www.telect.com • © 2011 Telect, Inc., All Rights Reserved, 139249-1 A0
13. Set the hardware aside
for reuse.
14. Remove the ground wire
using a 7/16” socket
wrench. Set the hardware
aside for reuse.
15. Reinstall the ground wire
on the opposite side of
the door.
16. Reinstall the rod control-
ler, rods, and rod guides
on the opposite side of
the door. Make sure the
orientation of the control-
ler and the rods is correct.
17. Reinstall the door handle
on the opposite side of
the door. Finger-tighten
the bolt.
Figure 13 - Removing Rod Controller
