Telecor VS1, Installation, Configuration & Operating Manual

Page: 159 / 281

148 VS1 Editor Configuration Application
You cannot use a Port configured for a CO Line in the Target Port text box. The following are also
valid entries:
AA1 to AA20 : (Auto Attendants 1–20)
ACD1 to ACD10 : (ACDs 1–10)
Null : Null rings nowhere. The null device is useful for configuring DISA.
VM{n}—VM{n} : would send the call to the Voice Mail of Extension {n} . Any valid Voice Mail
extension can be used after VM.
Properties Group Box
DISA : Enables Direct Inward System Access to internal dial tone from an external telephone not
connected to the VS1 Phone System. Many VS1 System installers choose to make DISA available
on only one CO port so that it is not generally accessible to every end-user at a particular site.
Providing access to a limited number of people can help reduce fraud and abuse of the DISA
feature. In addition the CO Port must be targeted correctly
(see “Direct Inward System Access” in
Reference section ) and an Extension must be configured with a DISA Account ( see “Setting up an
Extension Port Type” on page 149 ).
Note It is more effective to use a CO port that is not in a hunt group so that the CO number is
always available to the caller wanting DISA access. If the CO port is part of a hunt group,
it should be in the middle of the hunt group.
Gateway : This is used in conjunction with the Disconnect Signal property of an Extension port.
Enabling this option causes the CO port to respond to a “D” DTMF tone as disconnect. It is not
ordinarily used with a CO port. When selected, and the system hears a “D” DTMF tone, it
automatically disconnects the call.
Caller ID : When selected, this option enables the system to add additional ring pauses before it
starts ringing the Target Ports. The additional ring pauses allow the Target Ports time to wait for the
Caller ID.
Ring Over Pager : If a call rings the CO port, an audible ring is heard over a paging system
connected to the first Zone Pager Output of a PEU-205. The call can then be picked up from any
extension by dialing
#8 and the extension of where the call is ringing.
Music 1 : When a caller on the CO Line is placed on hold, the music source connected to Music
Input 1 on PEU 205 or DCU is played for the caller. If an internal call is placed on hold the caller
will always hear the Music 1 source.
Music 2 : When a caller on the CO Line is placed on hold, the music source connected to Music
Input 2 on PEU 205 or DCU is played for the caller.
Loop Tape :When a caller on the CO Line is placed on hold, the Loop Tape number entered in the
Loop Tape text box is played for the caller.
Disconnect : The default setting is –1 , which keeps the default setting for the Default Disconnect
(.01) sec text box in System Configuration 1. The Default Disconnect in System Configuration 1 is a
global setting and is set to .04 sec, or 400 milliseconds. If you change the CO port Disconnect text
box, it only affects the specific CO port. Any drop in loop current equal to or larger than the defined
time results in a disconnect.
No Ext Flash : Disables external hookflashes on the CO port. Do not enable this feature on CO ports
that require external hookflashes, such as Centrex.